All categories
Add new FAQ
Add question
Open questions
Login
Login
Search
Advanced search
Questions in Network
Page
1
out of
2
Pages
Is IPv6 address configuration via SLAAC possible for dedicated servers?
IPv6 configuration via SLAAC is not possible for our dedicated servers. For each dedicated server, we provide a /64 IPv6
3632 views
Why can't I reach my server in the same subnet ? (Linux)
To ensure the quality of service of our network, we have made changes that require you to also make changes
2223 views
Why can't I reach my server on the same subnet ? (Windows)
To ensure the quality of service of our network, we have made changes that require you to also make changes
1841 views
RDNS for customer owned address space
For customer address space announced via our AS24961 it is possible to have RDNS functionality within the customer panel. We
2201 views
How do I request additional IP addresses?
In principle, up to 31 additional IPv4 addresses per server - for vServers the maximum possible number is 7 IPs
3939 views
How do I configure a BGP Session to the Routeservers?
Before you follow this FAQ article, please read our FAQ article abouthow to get an BGP session. This is supported
21345 views
Is it possible to get a BGP session?
Yes, this is possible for our Co-Location customers. We will provideyou with a full-table BGP session through our three multi-hop
5335 views
Is internal traffic counted towards the data volume?
Internal traffic is not billed on the data volume. If the bandwidth is reduced due to exceeding the data volume,
1761 views
Can I transfer my additional IP to another server?
unfortunately not all IP's can be transferred from all servers:vServer <-> Dedicated server - Not possiblevServer <-> Root-Server - Not
2012 views
I get a DDoS, what can I do?
if you get a (small) DDoS attack, you can already block it using iptables (Linux) or the Windows firewall. If this
3528 views
How can I use my own address space or an assigned subnet within myLoc`s network?
For IPv4 we support routing on /32 granularity among all dedicated server and all root server products within the same
5274 views
How to announce my own IPv4/IPv6 address space via myLoc?
The following strict requirements need to be fulfilled prior to the announcement via our AS24961: We strictly require an exact matching
7066 views
What is my network configuration?
You will find the correct network configuration in the ZKM, with your respective contract:Configuration examples*** Important ***For the sake of
2692 views
What to do if network issues occur? (speed problems)
If you have issues with the network speed (Download/Upload) of your server, please perform the following while the server is
4501 views
Analyze network issues using MTR
If network issues occur, for example high latency, less bandwidth or packet loss an analysis is necessary. You must check
5774 views
How do I recognize the current network connection of my server?
For Windows: To see the current network connection of your server, you must display the adapter settings of your network adapter
3765 views
My server lagged what should I do?
Short interruptions in online games or radio streams are not always due to network problems. These dropouts are often caused
1960 views
What is the network configuration of my Virtual Machine ?
When a virtual machine is created on the host system, the network configuration of the VM is always as follows: IP:
4988 views
How do I set up IPv6 on my server?
To set up Ipv6 on your server, you need the IPv6 information from your ZKM: Attention: Please use only the IPv6
9852 views
General information about using a failover IP
The use of failover IP requires that you keep your data synchronous between both servers. There are basically different procedures
2102 views
1
2
→
⇥
one category up
Network
Subcategories