Questions in Network

Page 1 out of 2 Pages

• Is IPv6 address configuration via SLAAC possible for dedicated servers?

    IPv6 configuration via SLAAC is not possible for our dedicated servers. For each dedicated server, we provide a /64 IPv6
  3637 views
• Why can't I reach my server in the same subnet ? (Linux)

  To ensure the quality of service of our network, we have made changes that require you to also make changes
  2228 views
• Why can't I reach my server on the same subnet ? (Windows)

  To ensure the quality of service of our network, we have made changes that require you to also make changes
  1848 views
• RDNS for customer owned address space

  For customer address space announced via our AS24961 it is possible to have RDNS functionality within the customer panel. We
  2205 views
• How do I request additional IP addresses?

  In principle, up to 31 additional IPv4 addresses per server - for vServers the maximum possible number is 7 IPs
  3946 views
• How do I configure a BGP Session to the Routeservers?

  Before you follow this FAQ article, please read our FAQ article abouthow to get an BGP session. This is supported
  23262 views
• Is it possible to get a BGP session?

  Yes, this is possible for our Co-Location customers. We will provideyou with a full-table BGP session through our three multi-hop
  14422 views
• Is internal traffic counted towards the data volume?

  Internal traffic is not billed on the data volume. If the bandwidth is reduced due to exceeding the data volume,
  1766 views
• Can I transfer my additional IP to another server?

  unfortunately not all IP's can be transferred from all servers:vServer <-> Dedicated server - Not possiblevServer <-> Root-Server - Not
  2021 views
• I get a DDoS, what can I do?

  if you get a (small) DDoS attack, you can already block it using iptables (Linux) or the Windows firewall.   If this
  3530 views
• How can I use my own address space or an assigned subnet within myLoc`s network?

  For IPv4 we support routing on /32 granularity among all dedicated server and all root server products within the same
  5290 views
• How to announce my own IPv4/IPv6 address space via myLoc?

  The following strict requirements need to be fulfilled prior to the announcement via our AS24961: We strictly require an exact matching
  7079 views
• What is my network configuration?

  You will find the correct network configuration in the ZKM, with your respective contract:Configuration examples*** Important ***For the sake of
  2700 views
• What to do if network issues occur? (speed problems)

  If you have issues with the network speed (Download/Upload) of your server, please perform the following while the server is
  4562 views
• Analyze network issues using MTR

  If network issues occur, for example high latency, less bandwidth or packet loss an analysis is necessary. You must check
  5782 views
• How do I recognize the current network connection of my server?

  For Windows: To see the current network connection of your server, you must display the adapter settings of your network adapter
  3767 views
• My server lagged what should I do?

  Short interruptions in online games or radio streams are not always due to network problems. These dropouts are often caused
  1969 views
• What is the network configuration of my Virtual Machine ?

  When a virtual machine is created on the host system, the network configuration of the VM is always as follows: IP:
  5000 views
• How do I set up IPv6 on my server?

  To set up Ipv6 on your server, you need the IPv6 information from your ZKM: Attention: Please use only the IPv6
  9927 views
• General information about using a failover IP

  The use of failover IP requires that you keep your data synchronous between both servers. There are basically different procedures
  2113 views

• 1
  
• 2
  
• →
  
• ⇥

one category up